Morse Command Rack Replacement Cables

Teleflex Marine Mechanical Steering MECHANICAL STEERING measuring How to Measure Steering Cables “Measure Twice. Order Once.” Replacement of Existing Cable: If possible, find the part number stamped on the plastic jacket of the old cable. If you removed the old cable, measure for the replacement cable as follows: For Rotary Steering Cable Replacement, Measure Existing Cable as follows: Measure plastic cable jacket (“Y” dimension, shown in above drawing) in inches, add 18”, and round up to next foot. Order that length cable. New Installation: Measure cable routing path from wheel center line to engine connection, as follows: A = Center line of wheel to gunwale (or deck, if routed downward), B = Dash to transom, C = Gunwale to centerline of cable connection at centered tiller. For Cable Installations through the Engine Tilt Tube: Add A, B & C + 6”, then round up to the next foot. Order that length cable. For Cables Mounted to Transom, Splashwell or Stringer: Add A, B & C, then subtract 6” and round up to the next foot. Order that length cable. TYPICAL SINGLE STATION ROUTING A B C A single-cable, starboard drive push-pull mechanical cable system is shown in this diagram. If your mechanical system is different than the one depicted and/or you have any questions about mechanical steering after reviewing this guide, please contact Teleflex (Mechanical) Technical Service at (610)-495-7011 or www.teleflexmarine.com. Cable routings (such as those found on pontoon boats) may vary from this drawing. Confirm length by laying a garden hose or similar object) along cable path and measure run from wheel to engine connection point.